Prohashing Mining Pool Forums

When your Antminer's fault light is flashing red, you can restore it by restarting.
There are two ways to restart the miner. The first is to turn off the miner, then turn it on again. The second is to click "Reboot" on the miner interface, as shown below:
Miner Backstage> System> Reboot

Of course, there are many possibilities to cause the red light to flash. If it cannot be solved by restarting, you need to repair it according to the inspection results.

sometimes reload the configuration will also help the red light flashing.

It's critical to debug your Antminer as soon as you notice a flashing red light. Make sure the connections and power supply are secure by first inspecting them. Next, check for any problems with the hashing boards, such as loose connections or overheating. For further instructions, see the owner's handbook or look for discussion boards online. Quick intervention can save hardware damage and downtime.GB Whatsapp

So, I've seen the posts of the red light on the face of the surge.
final grade calculator