Page 1 of 1
Increased profitability by 1%
Posted: Mon Jun 11, 2018 10:58 am
by Steve Sokolowski
Following our examination of profits after correcting an issue which overpaid miners with large hashrates who only connected to the pool for short periods of time, we are now confident enough to increase profits by an additional 1%. I made the change this morning.
That brings the total increase to miners to 3%. We may be able to pass on an additional 1% next week, depending on an analysis we perform after seeing the effects of this increase.
Re: Increased profitability by 1%
Posted: Mon Jun 11, 2018 11:34 am
by cc4506
And I thank you! As bad as the market is every % counts!
Re: Increased profitability by 1%
Posted: Mon Jun 11, 2018 4:21 pm
by alim
Fantastic, thank you!
At periods through the day, the hashrate difference has been up to 200 MHz, which seems to have cleared on rebooting the miner a few times. What I think I have observed is that it is worse when a block is found. Thanks for investigating. I would prefer to leave my miners pointed here
Re: Increased profitability by 1%
Posted: Mon Jun 11, 2018 4:45 pm
by Steve Sokolowski
alim wrote:Fantastic, thank you!
At periods through the day, the hashrate difference has been up to 200 MHz, which seems to have cleared on rebooting the miner a few times. What I think I have observed is that it is worse when a block is found. Thanks for investigating. I would prefer to leave my miners pointed here
Did the difference clear permanently and now there is no issue? Or, does it recur after a period of time?
Re: Increased profitability by 1%
Posted: Tue Jun 12, 2018 3:07 am
by alim
Steve, it reoccurs everytime I reboot - I think it is related to whatever you have put on the front end. I reboot the L3 when the hash rate is showing 100MHz lower than what the miner shows.
I've now set two of mine to solo mine as they seem particularly problematic and I won't have time during the day to check.