Prohashing Mining Pool Forums

Hi, I switched to Prohashing today with my miners using these settings:

pool: stratum+tcp://prohashing.com:3333
worker: xx
password: d=131072 a=scrypt g=dynamic n=xx1 m=pps

But the workers are not showing up. Miner status panel reads: "DEAD" for this pool.

What am I doing wrong? I've mined with these settings plenty of times.

Thank you

quasarbeast wrote:Hi, I switched to Prohashing today with my miners using these settings:

pool: stratum+tcp://prohashing.com:3333
worker: xx
password: d=131072 a=scrypt g=dynamic n=xx1 m=pps

But the workers are not showing up. Miner status panel reads: "DEAD" for this pool.

What am I doing wrong? I've mined with these settings plenty of times.

Thank you

ok, it's working now!
that was strange...

Actually, they're dead again. Hmm, what's going on??

Depends how you are determining its DEAD.
You logged into the miner and the miner's status says DEAD?

Or you logged into the prohashing website and just arent seeing your miners listed there?

The miner status in the control panel for the miners.
Status can say "Alive" or "Dead", which I admit, is an odd choice of state nomenclature, a bit dramatic. But there you go.
My workers are Alive with the prohash pool, at the moment of this response. They've been Dead twice when I checked.

At this very moment, 2 out of 3 of my miners are "Dead" on prohashing.

I've mined here a few times over the last 6 weeks or so. This is the first time this has happened to me.

I reset the miners, now 3/3 are Dead