Very Newbie- Where do I add the addnode parameter

brodie_86 · Post by **brodie_86** » Sat Feb 24, 2018 11:15 pm

Very new to mining,
I have been trying to mine a very low difficulty static coin for a couple of weeks no... without success...i keep on getting an error where coin is not found with the "c=coin" parameter and error: coin/algorithm is incorrect when I use "c-coin m=solo". I was thinking to add the addnode parameter to see if this would help, but I have no idea where to add this parameter. Any help would be greatly appreciated!

JackNRochNY · Post by **JackNRochNY** » Sat Feb 24, 2018 11:41 pm

1.) What coin are you trying to mine?
2.) What interface are you using to input your password arguements? This site only does Scrypt and X11 algorithms
3.) What type of mining hardware are you using?

brodie_86 · Post by **brodie_86** » Sun Feb 25, 2018 12:02 am

I am trying to mine a low difficulty coin like Rabbitcoin
Bfgminer is my mining software
I am using 1 x Asic Scypt USB miner Moonlander 2

Configuration

bfgminer.exe --scrypt -o stratum+tcp://prohashing.com:3333/#skipcbcheck -u webuserlogin.1 -p "c=Rabbitcoin",d=128 -S MLD:all --set MLD:clock=756 pause

Thank-you in advance!!!

JackNRochNY · Post by **JackNRochNY** » Sun Feb 25, 2018 4:48 am

I tired on my L3+ to run Rabbitcoin and it is NOT working. Don't know if it is an issue with Prohashing or something else. Sorry

brodie_86 · Post by **brodie_86** » Sun Feb 25, 2018 10:44 pm

Thanks, very much appreciated

Very Newbie- Where do I add the addnode parameter

Very Newbie- Where do I add the addnode parameter

Re: Very Newbie- Where do I add the addnode parameter

Re: Very Newbie- Where do I add the addnode parameter

Re: Very Newbie- Where do I add the addnode parameter

Re: Very Newbie- Where do I add the addnode parameter